SINTERIT Lisa Pro - Page 39

Sinterit LISA PRO User Manual | 39
Cleaning with Sinterit Cleaning System:
Use the Sinterit Cleaning System and remove
all powder from the Print Chamber.
Use the appropriate nozzle for Antistatic hose
to remove the powder.
Incorrect and correct removing the powder from the Print Chamber.
8. Clean the space around the Beds and under the Recoater. To move the Recoater use
(right) or (left) buttons on
the screen.
9. When the cleaning is nished and the DONE button is pressed, a screen will appear with a message about the
amount of powder that needs to be added to refresh the powder taken out of the printer. This is a necessary process,
especially for polyamides, to print correctly in the next printing cycle.
10. After adding Fresh Powder as shown on the screen and pressing the DONE button, the cleaning process will be
completed. The printer will return to the MAIN MENU screen.
|
BACK DONE
CLEANING STEP 7 AND 8/9
Remove any remaining powder
from area around beds
Move Recoater for better access
Recoater
BACK DONE
CLEANING STEP 9/9
Cleaning the printer
Add 0.2 litres of Fresh Powder
to the powder removed from the printer
The screen for the Recoater manual moving. The printer will show you how much to add Fresh
Powder to refresh the powder from the printer.