SINTERIT Lisa Pro - General Safety Rules

Sinterit LISA PRO User Manual | 6
IMPORTANT!
• The product should be placed on a at, stable surface that extends beyond all edges of the
product.
• If you place the product by the wall, the distance between the product and the wall should be
greater than 50 [cm] / 20 [in].
• We suggest using the Sinterit Platform. Its dimensions are adapted to the requirements of the
Sinterit Lisa PRO printer.
• The product will not work properly if it is set at an angle.
STOP!
Do not place or store the printer:
• outdoors;
• near water, or heat sources;
• in areas with large amounts of dust;
• in places subject to shocks, vibrations, high temperature and/or humidity;
• extreme changes in temperature and humidity;
• near inammable and volatile substances, concentrated acids or corrosive vapours;
• in places easily accessible to children and animals.
STOP!
• The printer emits large amounts of heat (60 [°C] / 140 [°F]), and therefore it is
prohibited to place it on the wood or wooden furniture.
• Never use wood, equipment with wooden elements and ammable substances
while working with the printer.
• The min. distance between the printer and wooden parts is 50 [cm] / 20 [in].
STOP!
• The printer must not be operated in a corrosive or explosive environment.
• Avoid using the device close to open ames or sources of heat.
• Do not disconnect while the circuit is live or unless the area is free of ignitable
concentrations.
• Do not connect or disconnect when energized.
B. GENERAL SAFETY RULES
WARNING!
• Only trained and qualied personnel should install, replace or service the equipment.
• The device should be installed in accordance with these instructions and by trained personnel.
WARNING!
• Only adults should use the printer.
• When using the machine, mind other people, especially children.
ATTENTION!
• Risk of crushing upper limbs while closing the printer Lid.
• Never place hands between the Lid and Print Chamber while closing.
• Do not put your hands in the Service area of the BEDs when the BEDs are
running (in case of a removed Removeable Front Panel).
• Be aware when removing and installing the lid from the Nitrogen chamber and
Overow Bin.
• Do not remove the Removeable Front Panel during printer operation.