SINTERIT Lisa Pro - Finishing the Print and Printout Removal

Sinterit LISA PRO User Manual | 34
11. Finishing the print
A. REMOVING THE PRINTOUT
ATTENTION!
• Before starting any work with powder, always wear adequate protective clothing,
eyewear, face mask, and gloves.
• A suitable set is included in the DEDICATED POWDER TOOLS for Lisa PRO printer as
PERSONAL PROTECTION kit.
IMPORTANT!
• The system will guide you one by one through the process of pulling the printout and
cleaning the printer (next chapters).
• Please read the messages on the LCD screen carefully.
• The BACK button takes you back to the previous screen (if you missed something by
accident or want to take a step again).
1. When the process will be nished, the information of the
possibility to remove the printout will be displayed.
• Clicking the REMOVE PRINT button will start the process of
pulling out the printout and redirect to the next steps.
• Clicking on the MAIN MENU button will cancel the print
pullout process and return to the main screen.
MAIN MENU REMOVE PRINT
sample.scode
Printing nished
Printing nish screen.
2. Press the “UNLOCK LID” button on the LCD screen to open
the Lid.
Remember: The Lid’s electrolock deactivates for 10
seconds. After this time, it will re-activate).
3. Softly press the Lid and then lift it.
Look out! The lid is quite heavy.
BACK UNLOCK LID
Printer lid has to be opened
to operate the printer
Unlock and open the lid
36.6°C
Deactivate the lock to open the Lid.
IMPORTANT!
• The blockade of the printer Lid is engaged up until the internal temperature
will not drop below 50 [°C].
• There is no possibility to open the Lid before the temperature drops.
• Remember that the print inside the printer may still be hot, even though the
printer has cooled down!