SINTERIT LISA - Page 10

10 | Sinterit Lisa printer SHORTENED USER GUIDE
18. When the levelling is done and the RECOATER has
returned to its default position, the cleaning process
must be initiated.
a. Clean the Infrared Heaters (short
19
and long
ones
21
), use a brush or clean and dry cotton
cloth.
b. “CAREFULLY CLEAN THE VISION WINDOWS
OF THE CAMERA AND PYROMETERS” message
image will appear (Image 26).
Use a soft cloth soaked with alcohol (ethanol or
salicylic spirit 2%) and to very carefully clean the
windows of the PRINT Bed pyrometer
32
and
FEED Bed pyrometer
33
. Wipe both windows
dry.
c. After that, carefully clean the RECOATER guide
bar. Also, use a soft cloth soaked with ethanol
(Image 27).
d. Lubricate the RECOATER’s bearing system and
guide bar with the included silicone oil (Image
28).
e. Conrm by clicking the “DONE” button after
you do all of the steps.
19. Ensure that no items left inside the printer and
gently close the Lid (Image 29).
Carefully clean the vision
windows of the camera
and pyrometers
Image 26. Clean the pyrometers window screen.
Clean the recoater
guide bar
Image 27. Clean the RECOATER guide bar screen.
Lubricate the
plain bearing
of the Recoater
with silicone
grease.
Image 28. Lubricate the RECOATER bearing system screen.
FileName_01.scode
Make sure there are no items left
inside the printer and close the lid
Image 29. Finalizing preparations for printing screen.
IMPORTANT!
If the quality of the distributed powder is unsatisfying, close the Lid and press the “BACK” button
on the LCD screen. Unlock Lid and start the Leveling process again.
20. Press “START PRINTING” button on the LCD screen
and the printing process will start (Image 30).
21. The process will start with a slight delay (not
immediately after pressing the button).
Image 30. Start printing screen.