Sintrol S303 - General Information and Manual Usage

Page 5 | 45
1 General Information
1.1 Reading and storing the user manual
This user manual accompanies the S303 and S304 dust measuring instruments and contains important
information on installation, setup, calibration, and handling.
Before using the S303 or S304, read the user manual carefully. This particularly applies to the safety
instructions. Failure to do so may result in personal injury or damage to the S303 or S304. This user manual
must be accessible to those tasked with the installation and operation of the S303 or S304.
Store the user manual for further use. Make sure to include this user manual when passing the instrument on
to third parties.
1.2 Checking the S303 or S304 and package contents
Risk of damage!
If you are not cautious when opening the packaging with a sharp knife or
other pointed object, you may quickly damage the instrument.
 Be careful when opening and removing the instrument from the packaging.
1. Take the instrument out of the packaging.
2. Check to make sure that the delivery is complete (see 4.1 Standard Scope of delivery).
3. Check whether the S303 or S304 or individual parts are damaged. If this is the case, do not
use the instrument and contact the Sintrol Customer Service Department.
1.3 Overview of the life cycle operation
After unpacking the instrument, the whole life cycle operation shall be handled as follows:
 Choose the appropriate installation location (see chapter 6 Mechanical Installation)
 Install the instrument mechanically (see chapter 6 Mechanical Installation)
 Install the instrument electrically (see chapter 7 Electrical Installation and Wiring)
 Run Auto setup at normal conditions while Filtration system is intact and production running (see
chapter 8.2 Auto setup description)
 Change parameters and calibrate the instrument if necessary by using the local user interface or any of
the Sintrol software (see chapter 8.4 Parameter table for the local display (S303 or S304) or chapter 9
Sintrol DustTool Software)
 Use the instrument according to this manual
 Clean and maintain the instrument periodically (see chapter 11 Cleaning and Maintenance)
 If required do troubleshooting (see chapter 12 Troubleshooting)
 If you relocate the instrument repeat the whole installation, Auto setup and calibration procedure
 At the end of lifetime dispose the Instrument according to this manual (see chapter 17.2 Disposal of
the S300 Series)