STAR
13
2. Preparing
2.1 Special safety instructions
–
When performing check up,
maintenance repair and mount works
always switch off the P.T.O.shaft.
Switch off the engine and pull out the
ignition key. Secure tractor against
movements.
–
Maximum number of rotations is
540 rpm.
–
Nobody is allowed to stay between the
tractor and the machine when lifting or
lowering the swather with tractor
hydraulics.
–
Make sure nobody is in the danger area
of the swather before switching on the
P.T.O. shaft. High injury risk!
–
Pay attention to use protections
according to regulations when working
or driving on the road. Mount the light
equipment and check its functioning.
–
Never leave the driver seat during
working.
–
Maximum P.T.O. shaft rotation of the swather is 540
rpm.
–
Tractor must have three hydraulic connections, one
for single circuit and two for parallel circuit.
–
Electric connection for lights.
2.2 Attaching to the tractor
–
When attaching the swather make sure
nobody is between the tractor and the
swather.
–
Place the swather on flat ground.
–
Attach the swather connection (1) to the lower
hydraulic hitch (2) and secure it with pin (3).
–
Lift the swather connection a bit with the lower
hydraulic hitch to lift the support leg (4) into
transport position and fix it. Do not ever remove the
support leg.
–
Connect the hydraulic tube for oneway-working pull
cylinders and hydraulic tubes for twoway-working
cylinders (connected circuit). Check the correct
functioning!
–
Connect the electric connection for lights.
–
Put the rope loosely into the cabin to avoid the
opening of the stop with unintentional pull.
–
Fix the lower hydraulic hitch (2) with draw bar (5)
and stabilizer (6).
Swather connection must be horizontal, it
is not allowed to move left or right.
Check the correct functioning of hydraulics
and lights!
4
1
1
3
2
5
6
6
5
2
To Next Page
Loading...
