Need help?Do you have a question about the Sirit INfinity 510 and is the answer not in the manual?
General| Air Interface Protocol | EPCglobal UHF Class 1 Gen 2 / ISO 18000-6C |
|---|---|
| Protocol Support | EPCglobal UHF Class 1 Gen 2 / ISO 18000-6C |
| Operating Temperature | -20°C to +55°C |
| Operating Frequency | 902-928 MHz |
| Frequency Range | 865-868 MHz, 902-928 MHz |
| RF Power Output | 1 W (30 dBm) |
| Power Output | 1 W (30 dBm) |
| Data Interface | Ethernet, RS-232 |
| Interface | Ethernet, RS-232 |
| Power Supply | 12-24 VDC |
| Read Range | Up to 9 m (depending on antenna and tag) |
| Antenna Ports | 4 ports |
Details the content covered in the user guide, including safety, overview, installation, software, configuration, operation, and specifications.
Identifies the target readers and their prerequisite knowledge for installing, configuring, and operating the INfinity 510.
Introduces the INfinity 510 as a multiprotocol, multiregional RFID System operating in the UHF band.
Illustrates the power supply and various I/O connections for the INfinity 510 reader, including Ethernet, RS-232, and antenna ports.
Explains the function of the four status LEDs (Sense, Transmit, Fault, Power) on the INfinity 510 enclosure.
Covers physical mounting aspects, including reader dimensions, weight support, and various wall mounting options.
Details antenna mounting and includes a critical warning about FCC radiation exposure limits for safe installation.
Covers electrical installation, focusing on serial port connection and general electrical hookup overview.
Details Ethernet and digital I/O connections, antenna termination, and power connection procedures.
Guides through the installation of the Reader Startup Tool (RST) software from the system CD, including setup wizard steps.
Covers launching the RST application, initial reader setup wizard, firewall handling, and default login procedures.
Details selecting region, installation type, protocols, antenna configuration, and estimating tag volume.
Finalizes the initial reader setup by clicking 'Finish' in the setup wizard, completing the configuration process.
Explains basic operation using the Reader Operation Tool (ROT) via the RST application, including login and operating modes.
Covers monitoring tag performance and accessing advanced setup options via the reader's embedded web interface.
Details reader specifications, environmental operating conditions, and optional battery specifications.
Lists specifications for power supply, RS-232, and Ethernet LAN interfaces, including connectors and signals.
Provides specifications for digital I/O and antennas, including signal pinouts, gain, impedance, and regulatory cautions.
Covers power disconnect device requirements and FCC radiation exposure warnings for antenna installation.
Warns about the risk of explosion from incorrect battery replacement and advises using the specified type and designation.
To Next Page