Log On to Web Management Interface
Make sure the IP camera is correctly powered (Power LED is on), and then launch
your browser and type the IP address of the IP camera in address bar.
You should be prompted to input the user name and password:
The default user name is ‘admin’ (in lower case) and password is ‘admin’.
Click ‘OK’ to continue after user name and password has entered.
If you’re rejected, maybe the password has been modified previously. This should
not happen if this is a newly-purchased camera, however, if you get the camera
from someone else, the password would be changed. Please try to obtain the
correct user name / password, or you’ll have to reset the camera to factory
defaults.
If you see this message when you login to the IP camera, please click the link to
download ActiveX:
Press ‘Run’ to download and install the ActiveX control:
To Next Page
Loading...
