3.6 Motion Detection
3.6.1 Basic Settings
The motion detection function makes this IP camera become your non-stop guard. You
don’t have to waste all the time monitoring the images from the camera, and camera will
detect all motions for you. Once motion is detected, a captured image will be sent to you
by Email or via FTP.
You can access this menu by clicking ‘Video Setup’ on the top of web management
interface, and opening the 'Motion Detection' tab.
The descriptions of every setting in this menu will be given below:
Item Description
Motion Detection
Enable
Select ‘Enable’ to start motion detection, and select ‘Disable’ to
disabled it.
Detection
Interval
Specify the time interval between two motion detections in seconds.
If a motion is detected after last detection time, and before next
detection time, nothing will be send by Email or via FTP.
Please specify a time interval that suites your need. If the time
interval is too long, you may not be able to know what is happened
between time interval; if the time interval is too short, you may
receive too much unnecessary images, and consumes too much disk
To Next Page
Loading...
