sitrex MX 8 - Page 35

ASSEMBLY STEPS
33
32. CAUTION
Attach washers 2 and nipples 3 to cylinders 1. Connect the curved end of hoses 4 to nipples 3.
Pass hoses 4 through rings A & B and connect to T connector 5 at the center of the machine.
Connect hose 6 to T connector 5 and secure in place with collars 7.
NOTE: Hose 6 will also be in the next few steps.
In this step, you will use:
Item 2:
2 - copper washers 3/8"
Item 3:
2 - nipples 3/8" - 3/8"
Item 4:
2 - 3/8" hoses, length 2060
(3/8" x 6' 9" 3/32)
Item 5:
1 - male T connector 3/8"
Item 6:
1 - 3/8" hose, length 2400
(3/8" x 7' 10" 1/2)
Item 7:
2 - hose collars D 18
(45/64")
32