MK32 User Manual V1.1
76
2023 SIYI Technology, All Rights Reserved
3. Confirm and start to “Connect”. The top progress bar in QGC starts to move,
which means the remote controller is communicate with QGC automatically.
Please wait until the datalink connection is established.
Mark
If it is your first time adding a new connection in QGC, please do not check the option
“Automatically Connect on Start”. It can be checked later when you confirm that the
datalink is connected successfully.
4.2.2 Mission Planner
1. In “SIYI TX” app, go to “Datalink”, and choose “USB COM” in “Connection”,
“PIX / PX4 / Ardupilot” in “Flight Controller”, and match the baud rate with the
flight controller TELEM port’s.
To Next Page
Loading...
