4
SKF LAGD 400
Safety recommendations
• The operating instructions should always be followed.
• Assure you connect the lubricator to the recommended voltage/
frequency range.
• Isolate the power supply to the unit before removing the front or
back cover.
• Do not expose the equipment to high humidity or direct contact
with water.
• Protect all tubes against damage and excessive heat.
• Replace any damaged tubes immediately.
• Only use original SKF lubrication tubes.
• Take care when opening the protection cover for the grease cartridge,
as a strong spring is inside. There is a risk that the protection cover will be
ejected with force.
• Installation and maintenance work may only be done by qualified
personnel.
• All repair work should be carried out by an SKF repair shop.
To Next Page
Loading...
