7
SKF LAGD 400
3. Technical data
Number of lubrication outlets 1 - 8
Suitable grease NLGI 1, 2 and 3
Maximum pressure 40 bar (600 psi)
Maximum tube length between the
lubricator and the lubrication point 5 m (16 ft)
Dispense rate 0,1 - 10 cm³/day
(0.003 -0.35 US fl.oz/day) per outlet
approx. 0,6 - 65 g/week
(0.02 - 2.3 oz/week) depending on
grease density
Power supply 100 - 240 VAC (50 - 60 Hz) or 24 VDC
Power consumption, maximum 12 W
Power supply connector DIN 43650 -Micro
Alarm conditions blocked feed lines, empty cartridge;
internal and external
Steering the lubricator can be switched on and off
by an external relay
Ambient temperature 0 - 50 °C (32 - 120 °F)
IP rating 54
Lubrication tubes 20 m (65 ft), Nylon, 6 x 1,5 mm
Boundary dimensions 170 x 130 x 530 mm (7 x 5.5 x 21 in)
Weight 3,4 kg (8 lb)
Note:
The dispense rate is based on a continuous supply of grease over a 24 hour period.
If external steering is used, the dispense setting needs to be corrected.
If, for example, the SKF DialSet program recommends 3 cc/day and the lubricator
will only dispense grease 8 hours/day, the dispense rate must be increased to
24 hours / 8 hours x 3 cc/day = 9 cc/day.
English
To Next Page
Loading...
