Dividing the luggage compartment
Fig. 155
Dividing the boot with variable
loading floor
›
To divide, lift the variable loading floor by the handle
A
and push in the rear
edge of the variable loading floor in the grooves
B
in the direction of the ar-
row » Fig. 155.
The variable loading floor is secured against movements in the grooves
B
.
Folding out takes place in reverse order.
The variable loading floor is divided in the same way in the upper and lower po-
sition.
Net partition
Using the net partition
Fig. 156 Open part of the roll-up luggage compartment cover / release
lever
Fig. 157 Correctly secure net partition behind the front seats in the
pulled-out state
The net partition can either be pulled out and secured from behind the rear
seats or behind the front seats.
Pull out and secure the net partition behind the rear seats
›
Fold out part
A
of the roll-up luggage compartment cover in the direction of
arrow » Fig. 156.
›
Pull out the net partition at the crossbar
C
, insert in one of the mountings
D
and push forwards » Fig. 157.
›
Insert the crossbar on the other side of the vehicle in the mounting
D
in the
same way.
›
Make sure that the crossbar is firmly seated in the two mountings
D
.
›
Fold back part
A
of the roll-up luggage compartment cover in the opposite
direction of the arrow » Fig. 156.
Using the net partition behind the rear seats
›
Fold out part
A
of the roll-up luggage compartment cover in the direction of
arrow » Fig. 156.
›
First pull the crossbar back slightly on the one side and then on the other
side and remove it from the mountings
D
» Fig. 157.
›
Hold the crossbar
C
in such a way that the net partition can slowly roll up
without being damaged.
›
Fold back part
A
of the roll-up luggage compartment cover in the opposite
direction of the arrow » Fig. 156.
112
Using the system
To Next Page
Loading...
