Pairing and connecting
Introduction to the subject
To connect a telephone with Infotainment, the two devices must be paired via
Bluetooth
®
.
Depending on the Infotainment type, up to 20 external devices can be paired
with the device. After reaching the maximum number, the pairing of the next
external device will replace that of the device that has not been used for the
longest period of time.
Connection to an already paired telephone is established automatically after
the ignition is switched on. Or, it is sufficient to search for the phone in the list
of paired devices.
The range of the connection to Infotainment is limited to the passenger com-
partment.
Compatibility and update
By reading the QR code » Fig. 170 on page 122 or after typing the following
address into the web browser, information about the compatibility of phones
and updates are available for Infotainment Bluetooth
®
can be displayed.
http://go.skoda.eu/compatibility
Conditions for pairing
The ignition is switched on.
The Bluetooth
®
function of Infotainment and the telephone is switched on.
The visibility of Infotainment and the telephone is switched on.
The telephone is within range of the Bluetooth
®
signal of Infotainment.
The telephone is compatible with Infotainment.
There is no external device connected to Infotainment using Apple
CarPlay.
Pairing and connection process
Pair the telephone with Infotainment
›
Search available Bluetooth
®
devices in your telephone.
›
Select the name of the Infotainment system.
The name of the Infotainment system can be checked in the Telephone main
menu if you tap on the function surface →
Bluetooth
in the
name:
menu item.
›
Confirm the PIN code (enter and confirm if necessary).
The phone is either connected to the Infotainment or just linked, depending on
the number of already connected external devices and on the use of the SIM
card inserted in the external module (applies to Infotainment Columbus)
» page 161.
Pair Infotainment with the telephone
›
If no telephone is connected to the Infotainment system, press the but-
ton/sensor field
and then tap the
Find telephone
function surface or press
the
sensor field, and then tap the function surface →
Find mobile phone
.
›
If one telephone is connected to the infotainment system, then, in the Tele-
phone main menu, tap on the
→
Find mobile phone
function surface.
›
If a SIM card with activated telephone services is inserted in the external
module of infotainment Columbus, then, in the Telephone main menu, tap on
the
→
Find mobile phone
function surface.
›
Select the desired telephone from the list of visited external Bluetooth
®
devi-
ces.
›
Confirm the PIN code (enter and confirm if necessary).
WARNING
Do not pair and connect a telephone to the Infotainment system while driv-
ing the vehicle - there is risk of an accident!
Connect phone using the rSAP profile
Applies to Infotainment Columbus with the SIM card slot in the external mod-
ule.
A phone that has been connected via the Bluetooth
®
rSAP profile (remote
transfer of SIM data) can be used for phone and data services.
Pair the phone with Infotainment
›
Turn on the ignition and switch on Infotainment.
›
In the Telephone main menu, switch on the →
Business phone “interface”
.
›
Switch on Bluetooth
®
visibility in the phone and allow the connection via the
Bluetooth
®
rSAP profile.
›
Search for a phone and connect to the device » page 160, Pair Infotainment
with the telephone.
160
Infotainment
To Next Page
Loading...
