Then a new route is calculated and route guidance starts.
Customise transit point
›
In the Navigation main menu, tap on the function surface →
Change route in
map
.
›
Touch the transit point
B
and move to a different location on the map.
›
Tap on the function surface .
Then a new route is calculated and route guidance starts.
Remove transit point
›
In the Navigation main menu, tap on the functional surface →
Change route in
map
.
›
Tap on function surface
Delete waypoint
.
›
Tap on the function surface .
Then a new route is calculated and route guidance starts.
route list
In the route list, it is possible to create routes, save, delete, or start navigation.
New route
›
In the Navigation main menu, tap on the function surface
→
Routes
→
New
route
.
Insert a route destination in one of the following ways.
›
Tap on the function surface
Enter destination
and enter a new destination.
›
Or: tap on the functional surface
destinations
and select a destination from the
list of saved destinations.
›
To save the created route, tap the functional surface
Store
.
›
Tap the functional surface
Start
to start route guidance.
route import
A prerequisite for importing the route is that the Infotainment Online
» page 14 services are activated.
A route that has been created in the user profile on the ŠKODA Connect Portal
website and sent to the Infotainment system can be imported into the Info-
tainment memory even before switching on the ignition .
If the route was created while the ignition was switched on and was sent to
the Infotainment system, Infotainment only offers to import this route after
the ignition has been switched off (for at least 15 minutes) and after it is
switched on again.
›
Switch on the ignition. When a new route is available, a message regarding
the option to import this route appears in the Infotainment screen automati-
cally .
If the user opts not to import the route immediately, the route can be impor-
ted later manually as follows.
›
In the Navigation main menu, tap on function surface →
Routes
Tap to
check if a new route is available.
›
Or: tap the
sensor field and then the function surface → .
›
The function surface
import routes
Tap.
If a new route available, then a message is displayed on the Infotainment.
›
Tap the function surface
Retrieve
to start route guidance.
After being successfully imported, the route is displayed in the list of saved
routes.
Managing saved routes
›
In the Navigation main menu, tap on the functional surface
→
Routes
.
›
Choose the desired route, and then select one of the following functions.
Clear saved route
- Edit the route » page 192, Route schedule
- Calculate the route and start route guidance » page 190, Route calcula-
tion and start route guidance
Waypoint mode
Introduction to the subject
Only valid for Infotainment Columbus.
This mode is suitable for off-road navigation or for areas where maps are not
available.
Infotainment allows the recording of waypoint tours driven using automatic of
manually entered waypoints.
Then there is the option to start route guidance to the stored waypoint tour or
to save the waypoint tour on the SD card.
Delete
Edit
Start
194
Infotainment
To Next Page
