SKS-Kinkel Elektronik GmbH
Indoor station HTV4600, Receiver, 6-wire
EN
Support Hotline: +49 (0) 2661 98088-112
Support E-Mail: support@sks-kinkel.de
Version No. 3.0
Document No. 97003704
38
8.4.3 Internal call addresses that are called from the indoor station
To be able to call other indoor stations in the same system (internal or group call, only possible with the 11-key
version of the HTV4600) their internal call addresses have to be programmed into one of the five additional keys.
To do so follow these steps:
Step Image Description
5
B2
Set the internal call address of the indoor station, the indoor station is
supposed to call when key 1 is pushed.
6
+
1
Keep hold of the programming button on the back of the device and also
keep hold of key 1 within two seconds. Hold both keys for 5 seconds
until a signal tone is heard indicating that the programming has been
successful.
In the following if key 1 is pushed, the respective indoor station will be
called.
7
B3
Set the internal call address of the indoor station, the indoor station is
supposed to call when key 2 is pushed.
8
+
2
Keep hold of the programming button on the back of the device and also
keep hold of key 2 within two seconds. Hold both keys for 5 seconds
until a signal tone is heard indicating that the programming has been
successful.
In the following if key 2 is pushed, the respective indoor station will be
called.
. . . . . . . . .
13
B5
Set the internal call address of the indoor station, the indoor station is
supposed to call when key 5 is pushed.
14
+
5
Keep hold of the programming button on the back of the device and also
keep hold of key 5 within two seconds. Hold both keys for 5 seconds
until a signal tone is heard indicating that the programming has been
successful.
In the following if key 5 is pushed, the respective indoor station will be
called.
Attention
If an internal call address is assigned to a key that has was assigned a dierent ad-
dress before, the original programming will be deleted.
To Next Page
Loading...
Need help?
General
