August 2007
SKYJACK, Page 14
Section 1 - About Your Aerial Platform
SJM & SJII Series
• DO NOT increase the lateral sur-
face area of the platform. In-
creasing the area exposed to the
wind will decrease machine sta-
bility.
• DO NOT drive or elevate the
aerial platform if it is not on firm
level surfaces. Do not drive el-
evated near depressions or holes
of any type, loading docks, de-
bris, drop-offs and surfaces that
may affect the stability of the
aerial platform.
• If Operation In Areas With
Holes Or Drop-offs Is Abso-
lutely Necessary, elevated driv-
ing shall not be allowed. Posi-
tion the aerial platform horizon-
tally only with the platform fully
lowered. After ensuring that all 4
wheels or outriggers have con-
tact with level firm surface, the
aerial platform can be elevated.
After elevation, the drive function
must not be activated.
• Elevated driving must only be
done on a firm level surface.
• DO NOT Ascend or descend a
grade steeper than 20% (3015
& 3219) or 25% (3220, 3226,
4620, 4626, 4830, 6826 & 6832).
Ascend or descend grades only
when fully lowered and then
only to the maximums noted
above.
Warning
Failure to heed the following safety precautions could
result in tip over, falling, crushing, or other hazards
leading to death or serious injury
• KNOW all Federal, State, Provincial and local rules
which apply to your MACHINE and JOBSITE.
•
DO NOT leave the aerial platform unattended with
the key in the key switch.
• WEAR all the protective clothing and personal
safety devices issued to you or called for by job
conditions.
• DO NOT wear loose clothing,
dangling neckties, scarves,
rings, wristwatches or other jew-
elry while operating this lift.
• AVOID entanglement with
ropes, cords or hoses.
• AVOID falling. Stay within the
boundaries of the guardrails.
• DO NOT raise the aerial platform
in windy or gusty conditions.
1-18. Safety Precautions
Know And Understand The Safety Precautions Before Going On To Next Section.
To Next Page
Loading...
Need help?
General
