1.
Position the opener on the floor below the header bracket. If the door
spring is in the way, have someone to hold the opener to allow the rail
to clear the spring.
2.
Align holes in rail with holes in header bracket.
3.
Slide clevis pin [D1] through holes in rail and bracket and secure with
hitch pin [D2] .
1. Lift the garage door opener and rest it on a ladder. Ensure the ladder is
high enough to allow the door open fully.
2. Fully open the door and place a 2x4 board between door and rail to
protect door.
Step 3 – Position the garage door opener
2’x4’
Board
Door
Track
Rail
D1
D2
Step 2 – Attach the rail to the header bracket
12
INSTALLATION
To Next Page
Loading...
