1. Press and hold the “SET” Button for 5 seconds until the LED
display shows
“ ”.
Note: Do not release the "SET" button when you see " " on
the LED display.
2. Press and hold the UP Button until the door is in the desired fully
open position.
Note: Use the DOWN button if the door opens too far. Press UP / DOWN
button momentarily to adjust the open travel limit as necessary.
3. Once the door is in the desired fully open position, press and release the
“SET” Button. The LED display will show “ ”.
IMPORTANT NOTE: For one-piece door installations refer to page 28.
Receiving Sensor
Avoid direct sunlight
WARNING
• Incorrect adjustment of garage door travel limits will
interfere with proper operation of safety reversal system.
• After making any adjustment, both safety beam sensors
and safety reversal system must be tested.
1. Press and release the “SET” Button, the LED display shows “ ”.
2. Press the button on the remote that you would like to program.
For keypad, enter the [PIN] [#]. Refer to page 28 for more information.
3. Once the remote / keypad is programmed, the LED display will be off
and you will hear one beep.
NOTE
Each programming step has a 30-second time limit for completion
after the function is initiated. Restart the step as many times as
necessary to complete the programming.
Each button on each remote must be programmed separately.
Step 1 – Programming remote / keypad
LED display
DOWN
button
UP
button
Step 2 – Programming the travel limits
22
PROGRAMMING
To Next Page
Loading...
Need help?
General
