EQUIPMENT INSTALLATION INTO VIPERJET
P-25
Assembly & Operation Manual
Equipment installation is a personal ven-
ture. There is one golden rule: Do it as
neat and logical as possible! This will
make faultfinding and service of compo-
nents easier. The Viper basically consist
of 6 circuits!
1. Servo wires
2. Power cables
3. Data cables
4. Pneumatic pipes
5. Fuel pipes
6. RX cable
Please try and separate these circuits as far
as possible. It is advisable not to run RX ca-
bles near any kind of electrical fields.
Make all switches and filler valves and
charging sockets easy accessible.
Photo 66
Photo 67
Photo 68
To Next Page
Loading...
