MODE FUNCTION
NOTE: Touch anyplace on the screen and the back light will light up and stay lit for 5
seconds.
To select an operational mode, press the MODE button or touch the MODE SECTION on
the touch screen.
ON• turns the appliance on, the ame icon will appear.
THERMO• sets the remote to Thermo mode.
OFF• turns the appliance off, the ame icon will disappear.
MODE
SET
PROG
Mode: Button
Mode: Touch
Portion
SETTING ºF / ºC SCALE
The factory setting for temperature is ºF. To change this setting to ºC, rst press and hold the UP touch button and the DOWN touch
button on the transmitter at the same time. Follow this same procedure to change from ºC back to ºF.
NOTE: When changing between the ºF and ºC scales, the set temperature defaults to the lowest temperature (45 ºF, or 6 ºC).
Press and hold the
• SET button, or touch the SET section on the touch screen, for 5 seconds. The hour section should begin to
ash. (Fig. #1)
Use the
• UP and DOWN touch buttons to select the hour, then press SET.
The minutes will be ashing. Use the
• UP and DOWN touch buttons to select the minute, the press SET. (Fig. #2)
The AM PM will be ashing. Use the
• UP and DOWN touch buttons to select one of them, then press SET. (Fig. #3)
One of the days of the week will be ashing (above the clock). Select the correct day by pressing the
• UP and DOWN touch but-
tons, then press SET. Your time will automatically be accepted. (Fig. #4)
SETTING THE CLOCK
Fig. #1 Fig. #2 Fig. #3 Fig. #4
THERMOSTAT FUNCTION
This remote control system can be thermostatically controlled when the transmitter is in the THERMO mode
(THERMO must be displayed on the screen). To set the desired room temperature, press the MODE button to
place the transmitter into thermo mode, then press the UP or DOWN touch buttons to select the desired room
temperature. The highest set temperature is 99 ºF (32 ºC).
REV. 3/5/09 Page 2
NOTE: The thermo feature operates the appliance whenever the room temperature varies a certain number of degrees from the set
temperature. This variation is called the “swing” or temperature differential. This feature lets the appliance turn off and on 2 ºF (1 ºC)
above or below the set temperature of the room. This is to cushion the number of times the appliance is turned on and off.
THERMO UPDATING FEATURE - TRANSMITTER
When in thermo mode, the transmitter reads the ROOM temperature every 2 minutes, checks the room temperature against the SET
temperature then sends a signal to the receiver.
To Next Page
Loading...
Need help?
General
