Skytech 5301P Installation And Operation Instructions

PROGRAM FUNCTION
This remote has two program segments: A weekday segment and a weekend segment. To enter program mode, push the PROG button
or touch the program portion of the touchscreen; the word PROGRAM will appear above the display time to indicate program operation
is active.
The factory presets are:
WEEKENDS
“P1 ON” 6:00 AM at 72ºF
“P1 OFF” 10:00 AM
“P2 ON” 5:00 PM at 72ºF
“P2 OFF” 10:00 PM
WEEKDAYS
“P1 ON” 5:00 AM at 72ºF
“P1 OFF” 9:00 AM
“P2 ON” 4:00 PM at 72ºF
“P2 OFF” 10:00 PM
The user may override the program function by putting the remote in manual ON mode. When the user turns the remote back to OFF
mode, the remote will resume regular program mode (the word PROGRAM is above the display time). To turn the program function off,
touch the program portion on the touchscreen, or press the PROG button. The word PROGRAM will disappear from the LCD screen.
EDITING PROGRAM SETTINGS
Press either the PROG button or touch the Program portion of the touch screen and hold for 5 seconds, the program section of the
LCD screen will begin to ash.
NOTE: P1 CAN ONLY BE SET FROM 12:00AM to 12:00PM
P2 CAN ONLY BE SET FROM 12:00PM to 12:00 AM
P1 ON and “S S” (Weekend Segment) should be ash-•
ing. Select the time you want your appliance to turn on
by using the UP and DOWN touch buttons. Then press
SET (See Fig. #1).
P1 OFF will be ashing. Select the time you want your •
appliance to turn off. Then press SET (See Fig. #2).
The set temperature will begin to ash. Use the • UP and
DOWN touch buttons to select a temperature for P1,
then press SET (See Fig. #3).
Now the P2 ON will begin to ash. Select the time you •
want your appliance to turn on by using the UP and
DOWN touch buttons. Then press SET. (See Fig. #4).
P2 OFF will be ashing. Select a time you want your •
appliance to turn off. Then press SET (See Fig. #5).
The set temperature will begin to ash. Use the • UP and
DOWN touch buttons to select a temperature for P2,
then press SET.
“MTWTF” (Weekday Segment) will replace “S S”. P1 •
ON will be ashing. Repeat the above steps to set the
ON and OFF times and set temperatures for weekdays.
(See Fig. #6)
1
2
3
4
5
Program Segment: Program 1, or Program 2 (other side of LCD screen).1.
Flame On: Time when you want your appliance to turn on.2.
Flame Off: Time when you want your appliance to turn off.3.
Weekend Segment: Saturday and Sunday.4.
Weekday Segment: Monday through Friday.5.
Fig. #1
Fig. #2
Fig. #3
Fig. #4
Fig. #5
Fig. #6
REV. 3/5/09 Page 3

Skytech 5301P Specifications

General

Brand	Skytech
Model	5301P
Category	Remote Control
Language	English