BATTERY LIFE
Life expectancy of the alkaline batteries in the transmitter and receiver should be at least 12 months. Check and replace all batteries:
Annually.•
When operating range becomes reduced.•
When transmissions are not received by the remote receiver.•
If the remote receiver batteries measure less than 5.3 volts (all four batteries in combination).•
If the hand held transmitter batteries measure less than 5.3 volts (all 4 batteries in combination).•
FCC REQUIREMENTS
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODI-
FICATIONS TO THE EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT
For Technical Service, call:
U.S. INQUIRIES
888/672-8929 or 260/459-1703
Web site: www.skytechsystem.com
CANADIAN INQUIRIES
877/472-3923
MANUFACTURED EXCLUSIVELY FOR SKYTECH II, INC
TROUBLE SHOOTING
Ifyouencounterproblemswithyourreplacesystem,theproblemmaybewitheitherthereplaceitselforwiththeremote.Review
thereplacemanufacturer’soperationmanualtomakesureallconnectionsareproperlymade.Thenchecktheoperationofthe
remote in the following manner:
Make sure all batteries are correctly installed in the transmitter and receiver. Also check that the batteries are fully charged.•
Checkbatteriesintransmittertomakesurecontactsaretouching(+)and(-)endsofbattery.Bendmetalcontactsinfortightert.•
Besurereceiverandtransmitterarewithin20’-25’operatingrange.•
Keep receiver from temperatures exceeding 130 degrees F. Battery life will be shortened if exposed to high temperatures.•
If receiver is installed in a tightly enclosed metal surrounding, the operating distance will be shortened.•
Makesurethehand-heldtransmitterandremotereceiverarecommunicatingproperly(seeSECURITYCODESsection).•
REV. 3/57/09 Page 7
WALL MOUNT
The transmitter can be placed on a wall using the mount provided.
Wood-Drill1/8’’pilotholesandinstallwithscrewsprovided.•
Plaster/Wallboard-Drill1/4’’holes,useahammertotapinthetwoplasticanchors.•
Then install with the screws provided.
THERMO SAFETY FEATURE
If the receiver at anytime should reach 130 ºF, the receiver will automatically shut down and begin to beep 3 beeps every 2 seconds.
Oncethetemperaturehasdroppedbetween120ºFand130ºF,theusercanreactivatetheappliancebypressingtheMODE key, but
the beeping will continue until temperatures drop below 120ºF. This is to tell the user that the receiver needs to be relocated to reduce
temperatures.
If this situation happens, the receiver should be placed somewhere else where it will not reach temperatures in excess of 130ºF.
To Next Page
Loading...
Need help?
General
