Operation SMA America, LLC
54 BeamBT-eng-BUS110712 User Manual
7.7 Sunny Beam Alarms
The Sunny Beam has a buzzer which emits an alarm when an "Error" event occurs or when the battery
state is too low. For more information see section 12 "Troubleshooting" (page84).
7.7.1 Enable / Disable Alarm for Errors
When the "Error" event occurs, an alarm will be sounded and
the error symbol will be shown in the chart view. The alarm is
repeated after a certain interval set by the user until you press
the button, however, not for more than 24 hours.
1. Select "Settings > Alerts".
2. Select "Signal every".
3. Set interval after which to repeat the alarm.
The default setting is 30 minutes. Select "- - -" if you do not want an alarm to be sounded for
errors.
☑ The alarm for errors has been set.
I Serial number of the inverter where the event occurred.
Position Meaning
To Next Page
Loading...