4 Operating the Off-Grid Inverter with Sunny Remote Control SMA Solar Technology AG
36 SI80H-BE-BEN120810 Operating Manual
4.4.7 Directly Accessing Parameters
Any parameter can be accessed directly by entering a five-digit number. The five-digit number is
composed as follows:
• The first three digits are the menu number.
• The last two digits are the parameter number.
1. Switch to installer mode (see Section 4.4.5).
2. Select the parameter 600.02 Select Number and set the five-digit number.
☑ The parameter is displayed.
✖ The display shows Item not Found?
You cannot access the parameter in installer mode.
• Push the button and switch to expert mode (see Section 4.4.2).
The number set is not correct.
•Press the button and enter the number again.
Example: Five-digit number for direct parameter access
You want to use parameter 111.01 TotInvPwrAt to show the entire active power of the off-grid
inverter in a cluster. The five-digit number for directly accessing this parameter is 11101.
To Next Page
Loading...
