SMA SUNNY TRIPOWER CORE1 - Page 4

Table of Contents
SMA Solar Technology AG
Operating manualSTP50-40-BE-en-154
6.4.4 Connection to the Multifunction Relay .................................................. 42
6.5 DC Connection........................................................................................................... 44
6.5.1 Requirements for the DC Connection.................................................... 44
6.5.2 Assembling the DC Connectors............................................................. 44
6.5.3 Connecting the PV Array........................................................................ 46
6.5.4 Disassembling the DC Connectors ........................................................ 49
7 Commissioning ......................................................................... 51
7.1 Commissioning Procedure ......................................................................................... 51
7.2 Commissioning the Inverter........................................................................................ 52
7.3 Selecting a configuration option............................................................................... 53
7.4 Starting the Self-Test (for Italy and Dubai)................................................................ 55
8 Operation ................................................................................. 56
8.1 Activating and Operating the Display...................................................................... 56
8.2 Establishing a connection to the user interface ........................................................ 56
8.2.1 Establishing a Direct Connection via Ethernet ...................................... 56
8.2.2 Establishing a direct connection via WLAN ......................................... 57
8.2.3 Establishing a Connection via Ethernet in the local network ............... 58
8.2.4 Establishing a Connection via WLAN in the Local Network ............... 59
8.3 Logging In and Out of the User Interface................................................................. 60
8.4 Start Page Design of the User Interface.................................................................... 62
8.5 Displaying and Downloading the Stored Data........................................................ 65
8.6 Activating the Smart Inverter Screen......................................................................... 65
8.7 Starting the Installation Assistant............................................................................... 66
8.8 Activate WPS Function............................................................................................... 67
8.9 Switching WLAN On and Off................................................................................... 67
8.10 Switching the Dynamic Power Display Off............................................................... 68
8.11 Changing the Password............................................................................................. 69
8.12 Changing Operating Parameters.............................................................................. 69
8.13 Configuring the Country Data Set............................................................................. 70
8.14 Configuring the Active Power Mode ........................................................................ 71
8.15 Configuring Q on Demand 24/7............................................................................. 71
8.16 Changing the Operating Mode of the Multifunction Relay .................................... 72
8.17 Configuring the Modbus Function............................................................................. 73
8.18 Activating the Receipt of Control Signals (Only for Italy)........................................ 74
8.19 Setting SMA OptiTrac Global Peak ......................................................................... 75
8.20 Setting the Rated Residual Current of the Residual-Current Device ........................ 75
8.21 Activating String-Failure Detection ............................................................................ 75
8.22 Saving the Configuration in a File............................................................................. 76
8.23 Adopting a Configuration from a File....................................................................... 76