Smappee Infinity - Addendum 2 - Wi-Fi connection properties and firewall rules; Wi-Fi Connection Properties; Firewall Rules

Smappee Infinity – Installation manual – English
37
15. Addendum 2 – Wi-Fi connection properties
and firewall rules
Wi-Fi Connection properties
• 2.4 GHz Wi-Fi required, preferably with automatic channel selection.
• Networks without DHCP server are not supported.
• WPA or WPA2 encryption mandatory.
• Networks without security are not supported.
• SSID must be visible and should not be hidden during installation.
• Not all characters are allowed in the SSID or Wi-Fi password
• Allowed characters for SSID: [a-z],[A-Z],[0-9],[!#$%&'()*+-./:;<>?@[]^_`{|}~]
• Allowed characters for Wi-Fi password: [a-z],[A-Z],[0-9],[!"#$%&'()*+-./:;<>?@[\]^_`{|}~]
• MAC filtering must not be active on the router.
• Your firewall should allow Smappee to create outbound secure HTTP connections.
• The maximum number of characters for the WPA2/PSK is 20.
The DHCP of your router assigns the IP address of your Smappee.
Firewall rules
No specific firewall settings are required in your network. If you use a firewall, use the commonly
applied secure firewall rules:
• Inbound communication: All inbound ports closed. No port forwarding.
• Outbound communication: All outbound ports allowed.