Smappee Infinity – Installation manual – English
1. Safety instructions
Safety warning
Carrying out electrical work in a home or workplace can be dangerous.
The Power Box, CT Hub, Solid Core 3-Phase CT, Current Transformers (CT) and Rogowski coils are
usually installed inside the distribution board under a protective cover. The other components can
be installed both inside and outside the distribution board.
Only certified electricians may carry out the installation, which must be in accordance with the
national safety regulations.
Safety precautions
CAUTION: Risk of electric shock.
CAUTION: Refer to the accompanying documentation whenever you see this symbol.
DO NOT clamp or pull out NON-INSULATED conductors carrying DANGEROUS VOLTAGE
which could cause an electric shock, burns, or arc flash.
Please observe the following safety precautions to avoid potential electric shock, fire, or personal
injury:
• Use this product only for its intended purpose.
• Use the product indoors only.
• Only mount the power cable in a sealed enclosure.
• Locate a free fuse or install an additional fuse for the protection of the Power Box. Connect
the power cable according to the connection diagram, see next pages.
• The circuit breaker acts as the disconnect device and must meet IEC 60947-2
• Do not open the equipment or touch any of its electronic circuitry.
• Do not attempt to open, repair, or service any parts.
• Only use the cables delivered with the product.
• Do not use the product if damaged.
• Do not use damaged current transformers or cables.
• Do not immerse the product in water or any other liquids.
• Do not expose the product to heat, flame, or extreme cold.
Product identification
• Smappee Power Box: MOD-VAC-1
• Smappee CT Hub: MOD-IAC-1
• Smappee Solid Core 3-Phase CT: MOD-IAC-2
• Smappee Genius: MOD-GW-1
• Smappee Wi-Fi Connect: MOD-GW-2
• Smappee Connect: MOD-GW-3
• Smappee Input module: MOD-INP-1
• Smappee Output module: MOD-OUT-1
To Next Page
Loading...