Smappee Infinity – Installation manual – English
5. Initial setup and configuration
The first step of the Smappee Infinity installation is creating a location and defining the measured
loads and their properties. The location defines where the Smappee will be installed (e.g. house,
store, or site address).
This procedure is done with the Smappee Energy Monitor mobile app.
Remarks
• The Smappee App will guide you through the various steps to fill in all the required
information.
Steps
•
Log in to the Smappee App with the corresponding Smappee username or create a new
account.
•
Create a new location.
•
Follow the steps shown in the mobile app.
To add a new location under the same user account in the mobile app, go to Settings >
Your Locations > Add a new location.
To Next Page
Loading...
