Smappee Infinity – Installation manual – English
Maintenance
• Clean the outside only with a dry, clean cloth.
• Do not use abrasive agents or solvents.
Responsibility
• Assembly, connection, and use must be carried out in accordance with the installation
standards currently in force.
• The device must be installed in accordance with the instructions given in this manual.
• Failure to observe the instructions for installing this unit may compromise the device’s
intrinsic protection.
• The device must be placed in a system that complies with the applicable standards and safety
regulations of the country of installation.
• Cables may only be replaced with cables of the correct rating.
Explanation of the safety symbols
The table below explains the safety symbols.
Class II equipment does not require an earth connection.
This device has been tested according to IEC 62262 and complies to impact class 6
(Impact energy: 1 Joule).
Residual safety risk
• The device’s housing has IK06 impact immunity level. Therefore, it is essential that the housing
is not damaged during installation.
• When there is visible damage to the device’s housing, it is recommended to replace the device
to prevent any hazardous situation to occur.
To Next Page
Loading...