11
Replace Components
To Replace Components on your CMU:
Read Directions Before Programming
*MAKE SURE THAT NO COMPONENTS ARE BEING ACTIVATED WHEN YOU ARE TRYING TO REPLACE COMPONENTS
ON THE CMU.
Place new components in the order that you would like to program them. Pads will need to be on a hard at surface
and turned on in order to program correctly.
1. Put the CMU into the UNLOCK position.
2. Press and hold the REPLACE COMPONENTS button for 2 dings and a melodic conrmation tone then release.
3. Monitor screen will light up ashing the rst replaceable # and audibly say this #
4. You can replace this # or scroll through and choose which replaceable # you want to program by repeatedly
pressing REPLACE COMPONENTS until the desired # is ashing.
• Replaceable #’s are ones that already have a component programmed, to add a component to an empty #
please follow steps to add a component on page 6.
5. Activate First Component:
• Bed or Chair Sensor Pad - Apply pressure and release after 2-3 seconds.
• Nurse Call Button - Push button and then release (Red light on button will illuminate).
• Motion Sensor - Turn switch on and wave hand in front of sensor (This could take 10-15 seconds) then
turn o when CMU calls number.
• Pager with Reset Button - Press and release reset button.
• Floor Mat - Step on oor mat until CMU alerts.
6. A melodic conrmation tone will sound after you activate your component. The programmed # will then turn
solid and the next replaceable # will be ashing.
• If replacing more components, repeat steps #4-6.
• Press RESET on the CMU and then move to LOCK.
7. Test component(s).
If you have completed the steps above and need additional help, please feel
free to contact us and our world-class customer service team will be happy
to help. Call 800-650-3637.
To Next Page
Loading...
Need help?
General
