6
Setup - Programming/Add Components
To Program Components to Your CMU:
Numbers ashing across the screen of the Central Monitor indicates that there are no components currently
programmed into the Central Monitor.
*READ THESE INSTRUCTIONS FULLY BEFORE BEGINNING TO PROGRAM.
1. Insert batteries into all components requiring a battery.
2. Plug in AC adapter or insert 4-C batteries into the 433-CMU.
3. For bed and chair pads, apply 30 seconds of pressure to initialize pad(s).
4. Move the switch on the side of the CMU to the UNLOCK position.
5. Select ALARM or CALL on the side of the 433-CMU.
• ALARM is a siren sound.
• CALL is the tone selected using the VOICE/TONE button (Recommended).
6. Select the desired tone and volume on the 433-CMU.
• Press Voice/Tone until you get the desired tone or language.
7. Hold down the PROGRAM/ADD COMPONENTS Button. Wait until you hear 2 dings and a melodic
conrmation tone; then release button.
8. Monitor screen will light up ashing rst available # and audibly say this #. (This will be #1 if your
monitor is empty).
9. You can program that # or scroll through and choose which available # you want to program by
repeatedly pressing the PROGRAM/ADD COMPONENTS Button until the desired # is ashing.
• Note monitor will skip over any # that already has a programmed component. Please see
instructions on replacing components on Page 11 if you need to replace a #.
10. Activate First Component:
• Bed or Chair Sensor Pad - apply pressure and release after 2-3 seconds.
• Nurse Call Button - push button and then release (Red light on button will illuminate).
• Motion Sensor - turn switch on and wave hand in front of sensor (This could take 10-15 seconds)
then turn o when CMU calls number.
• Pager with Reset Button - press and release reset button on the pager.
• Floor Mat - turn on oor mat transmitter and step on oor mat until CMU alerts.
11. A melodic conrmation tone will sound after you activate your component. The programmed # will
then turn solid and the next available # will be ashing.
• If adding more components, repeat Steps #9-11.
• Press RESET on the CMU and then move to LOCK.
12. Test your system! Activate component, wait for alert then press the RESET Button to silence the alert.
IF YOUR SYSTEM IS PRE-PROGRAMMED, DO NOT
FOLLOW THE STEPS BELOW UNLESS YOU NEED
TO ADD MORE COMPONENTS. GO TO PAGE 5.
STOP
To Next Page
Loading...
Need help?
General
