CHAPTER 3
USING YOUR INTERACTIVE FLAT PANEL
16 smarttech.com/kb/170534
3. Connect a USB drive to the USB A receptacle on the bottom connector panel. See
Connecting your interactive flat panel on page5.
4. Using the remote control, select a file.
5. Press the Play button on the remote control to play or view the file.
Cleaning the interactive flat panel
Follow these instructions to clean the interactive flat panel without damaging its anti-glare coating
or other product components.
CAUTION
l Do not use permanent or dry-erase markers on the screen. If dry-erase markers are used on
the screen, remove the ink as soon as possible with a lint-free, non-abrasive cloth.
l Do not rub the screen with a dense or rough material.
l Do not apply pressure to the screen.
l Do not use cleaning solution or glass cleaner on the interactive flat panel screen, because
they can deteriorate or discolor the screen.
To clean the screen
1. Press the power button to turn off the display.
2. Wipe the screen with a lint-free, non-abrasive cloth.
Preventing condensation
The interactive flat panel screen contains layers of glass that can collect condensation, especially
in the following conditions:
l Temperature extremes with high humidity
l Rapid changes in humidity, which can occur when you operate the product near water (such as
a pool, kettle or air conditioner ventilator)
l Direct exposure to sunlight
l Cold air output from an air conditioner towards the bottom of the interactive flat panel.
To Next Page
Loading...
