SMART ebike - Page 25

X
Tighten clamping bolt ? with a torque
of 9 Nm (6.64 lb-ft).
X
After riding 30 km (19 miles), retighten
clamping bolt ? to the specified torque
of 9 Nm (6.64 lb-ft).
Adjusting the saddle position and angle
:
Bolts for securing the seat
X
Release both bolts : with a 5 mm
(0.2 in) Allen key.
The horizontal position of the seat can
be adjusted as well as its angle.
X
Move the seat horizontally and adjust the
angle to be level.
i When the ball of your foot is on the pedal
and the pedal is at its lowest point:
R
your knee should be slightly bent
R
your kneecap should be positioned in
a vertical line to the pedal axle
You have then set a good seat position.
X
Tighten both bolts : alternately, until
a torque of 12 Nm (8.85 lb-ft) is achieved.
X
After riding 30 km (19 miles), retighten
bolts : alternately to the specified
torque of 12 Nm (8.85 lb-ft).
Adjusting the grips
:
Grip
;
Clamping bolt
You can adjust grips : so that the balls of
the hands rest fully on the contact areas.
The wrist should then be as straight as pos-
sible. Try out the most comfortable posi-
tion of the grips for you.
X
Release clamping bolt ; on both
grips : using a 4 mm (0.16 in) Allen key.
X
Turn grips : to a comfortable position.
X
Make sure that grips : finish flush with
the ends of the handlebars.
X
Tighten clamping bolts ; to a torque of
5 Nm (3.69 lb-ft).
When grips : have been tightened to the
specified torque, it should no longer be
possible to turn them.
X
After riding 30 km (19 miles), retighten
clamping bolts ; to the specified tor-
que of 5 Nm (3.69 lb-ft).
Adjusting the seat position
23
>> Controls.
Z