SMART ebike - Removing

Mounting the smartphone cradle
Removing the stem face plate
Electrical connectors on the headlamp
Control console contact plate
:
Data cable
;
Generator sensor cable
=
Control console contact plate
?
Screw
A
Stem face plate
X
Remove control console (Y page 25).
X
Pull sensor cable ; off contact plate
=.
X
Loosen retainer of data cable : using a
screwdriver and detach data cable :
from contact plate =.
X
Unscrew screw ? using a T20 Torx wrench
and pull contact plate = upwards
slightly. As you do so, press against con-
tact plate = from underneath around
electrical connectors : and ;.
X
Pull face plate A backwards.
X
Pull contact plate = upwards.
Removing the cover
:
Screws for cover/headlamp casing
;
Cover
X
Unscrew screws : using a 2.5 mm (0.1 in)
Allen key.
X
Remove cover ;.
X
Screw in screws : for the headlamp cas-
ing again and tighten to a torque of
1 Nm (0.74 lb-ft).
Mounting the smartphone cradle
:
Front handlebar clamp screws
;
Rear handlebar clamp screws
X
Unscrew front handlebar clamp
screws : using a 5 mm (0.2 in) Allen key.
X
Position the smartphone cradle on the
handlebar clamp.
X
Insert screws : through the smartphone
cradle and handlebar clamp.
32
Stowing and features
>> Controls.