SMART ebike - Page 33

When transporting objects on the luggage
carrier, make sure that the tail light and
the reflectors on the tyre sidewalls are
clearly visible to other road users.
The luggage carrier designed for the smart
ebike is not suitable for carrying a child
seat.
Mounting the luggage carrier
:
Front screw on dropout
;
Luggage carrier
=
Frame clamp
?
Clamp screws
X
Loosen and unscrew screws : on the left
and right-hand side.
X
Loosen and unscrew screws ? on clamp
=.
X
Position the luggage carrier above the
rear wheel and insert screws : on both
sides.
X
Attach clamp = around the bike frame
and insert screws ?.
X
Tighten screws : on the left-hand and
right-hand side to a torque of 22 Nm
(16.23 lb-ft).
X
Tighten screws ? on clamp = to a torque
of 6 Nm (4.43 lb-ft).
X
After riding for 30 km (19 miles), re-
tighten screws : and ? to the specified
torques.
Smartphone cradle*
Notes
G
WARNING
Operating the ebike information systems
and communication units when riding the
ebike will distract you from the traffic
conditions. You could also lose control of
the ebike. There is a risk of an accident.
Only operate these units when the traffic
situation permits. If this is not possible,
pull over at a safe place and enter the
information when the ebike is parked.
The e-bike smartphone cradle is suitable
for smartphones with screen sizes of
between 8.89 cm (3.5 in) and 10.92 cm
(4.3 in).
You can rotate the smartphone cradle into
a landscape or portrait mode to suit the
application. It can also be adjusted into 4
different tilt positions without any tools.
You can also charge your smartphone during
a ride using the USB port underneath the
headlamp.
Always make sure that your smartphone is
securely engaged in the smartphone cradle.
Stowing and features
31
>> Controls.
* optional
Z