SMART ebike - Mounting

ebike with direction of travel to the right
:
Dropouts
;
Axle nut, right
=
Catch
?
Gear cable
i
Observe the instructions on handling
the drive belt (Y page 43)
X
Remove the battery (Y page 41).
X
Engage first gear (Y page 29).
X
Press catch = and detach gear cable ?.
ebike with direction of travel to the left
A
Data cable connector
B
Power cable connector
C
Axle nut, left
X
If necessary, allow the components to
cool down.
X
Detach data cable connector A.
X
Detach power cable connector B.
X
Loosen axle nuts ; and C (wrench size
15 mm (0.59 in)).
X
Hold rear wheel in place, lift the ebike
by the saddle.
The rear wheel slides out of dropouts :
X
Carefully remove the drive belt from the
pulley.
X
Set the rear wheel aside, ensuring that it
cannot fall over.
X
Slide the yellow transport lock between
the brake pads.
Mounting the rear wheel
ebike with direction of travel to the right
ebike with direction of travel to the left
:
Dropout, right
;
Washer with anti-twist lock (right)
=
Axle nut, right
?
Belt pulley, rear wheel
A
Dropout, left
B
Axle nut, left
C
Torque support
D
Washer (left)
Removing/mounting the rear wheel
59
>> Practical advice.
Z