EasyManua.ls Logo

SMART ebike - Charger; Partial Discharge; Full Discharge; Inactive

SMART ebike
80 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
R
Do not use the charger in damp locations
or in ambient temperatures below -10
(14 ) or above 40 (104 ).
R
Do not immerse the battery into water.
R
The battery and the charger do not have
to be serviced. Do not try to disassemble
or modify the battery or the charger. Do
not subject the battery to a high pres-
sure. Please note that high pressure can
be applied as a result of load from heavy
objects. You may not use a battery with a
damaged casing.
R
Keep the battery away from small chil-
dren.
R
If, while the battery is in use, is being
charged or is in storage, you notice that
the battery gets hot, develops a strong
smell, alters in appearance or behaves
abnormally in any way, stop using the
battery immediately.
Heat develops when charging the battery:
R
Make sure that there are no combustible
materials close to the battery when
charging.
R
When charging, place the charger and
battery on a non-combustible surface.
R
If you charge the battery while it is still
installed on the ebike, position the bike
in such way that a fire cannot spread.
R
Do not charge the battery on carpeted
floors.
R
Do not cover the battery and charger dur-
ing charging.
Notes on the charger
i
The charger supplied is suitable for a
voltage range of 100 - 240 V. The charger
does not need to be switched to the rel-
evant voltage range as it automatically
detects the voltage range.
The charger has no on/off switch. If you do
not require the charger, disconnect the
plug to save energy.
Notes on the battery
!
A deep battery discharge causes irre-
versible damage and capacity loss. If you
do not use the battery for longer periods,
charge the battery fully at regular inter-
vals and at least every 6 months.
Please follow the instructions below to
guarantee a long battery life:
R
ideally, charge the battery at a room
temperature of 20 (68 ). Before
charging, give the battery sufficient
time to reach this temperature.
R
avoid frequent full discharges. The bat-
tery prefers partial discharges. Lithium
ion batteries do not have memory effect.
R
brief discharges with subsequent
charges can cause an inconsistency
between the charge indicator and the
battery charge level. After approx-
imately 30 charges, allow the battery to
completely discharge and then re-charge
it. This will allow the charge indicator
to be periodically calibrated to the bat-
tery charge level.
Every lithium-ion battery is subject to
operational wear. Cell oxidation occurs as
a result of use and ageing. The battery
capacity decreases. The typical lifespan
of a lithium-ion battery is between
2 and 3 years, regardless of whether it is
used or not.
Battery protection mode
The battery switches to protection mode if:
R
the ebike is not used for two months
R
the battery has been drained fully and is
not charged within one week.
The battery is inactive in protection mode.
You can only activate the battery again
after a complete charge cycle.
The lighting system will not function if the
battery is in protection mode. Depending
on national regulations, it may be pro-
40
Charging the battery
>> Operation.

Table of Contents

Other manuals for SMART ebike