SMART ebike - Removing;Fitting the Control Console; Switching the System on the Control Console On;Off; Operation; Bike Mode

Removing/fitting the control console
Removing the control console
:
Control console
;
Fuse
X
To unlock control console :, press
safety catch ;.
Slide control console : out of the
holder.
Inserting the control console
X
Slide control console : into the holder
on the stem until safety catch ;
engages.
You will hear a clicking noise if the
safety catch is correctly engaged.
Switching the system on the control
console on/off
G
WARNING
Operating the ebike information systems
and communication units when riding the
ebike will distract you from the traffic
conditions. You could also lose control of
the ebike. There is a risk of an accident.
Only operate these units when the traffic
situation permits. If this is not possible,
pull over at a safe place and enter the
information when the ebike is parked.
:
Button Ü
;
Bike mode symbol
=
Button f
X
To switch on: press button : or button
= briefly on the control console.
An audible signal sounds to confirm the
system has been switched on. The system
runs through a self-diagnosis which ends
with a countdown on the speedometer.
The light and display lighting are
switched on. Indicator lamp _ appears
in the display.
i
Once you have started the system, it
remains in bike mode ; (i.e. normal
bicycle operation with no electric pedal
power assistance and with no generator
operation).
X
To switch off: press button : briefly.
An audible signal sounds to confirm the
system has been switched off.
Switching the system on the control console on/off
25
>> Controls.
Z