SMART ebike - Connecting

i
Observe the instructions on handling
the drive belt (Y page 43)
X
Remove yellow transport lock.
X
Carefully place the drive belt on rear
wheel belt pulley ?.
X
Carefully insert the rear wheel: position
the rear wheel in such a way that torque
support C can slide into left dropout
A.
X
Make sure that the brake disc slides
between the brake pads.
The rear wheel axle must be evenly posi-
tioned in dropouts : and A .
X
Push washer with anti-twist lock ; onto
the right side of the axle.
The flanged tab of washer ; must pro-
trude into dropout :.
X
Push washer D onto the left side of the
axle.
X
Place axle nuts = and B in position and
tighten them alternately.
X
Tighten both axle nuts = and B to a
torque of 40 Nm (29.5 lb-ft).
ebike with direction of travel to the left
:
Data cable connector
;
Power cable connector
X
Connect power cable connector ;
X
Connect data cable connector :
X
Install the battery (Y page 42).
X
Connect and adjust the gear cable
(Y page 60).
smart recommends that you have the drive
belt tension checked at a qualified spe-
cialist workshop.
Connecting and adjusting the gear
cable
Connecting the gear cable
ebike with direction of travel to the right
:
Shift cable
;
Catch
=
Sleeve
?
Gear cable
X
Using the twist-grip gearshift, engage
first gear (Y page 29).
X
Press and hold catch ; and slide sleeve
= as far as possible onto shift
cable :. Do not pull on shift cable :.
X
Release catch ;.
Gear cable ? is now connected.
X
Shift through the gears several times to
test the gearshift.
If all gears are easily engaged and
remain engaged, the gear cable does not
need to be adjusted. If this is not the
case, the gear cable needs to be adjusted
(Y page 61).
60
Removing/mounting the rear wheel
>> Practical advice.