EasyManua.ls Logo

SMART ebike - Transporting the Ebike

SMART ebike
80 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The approved tyres (Y page 70) have a
directional design. An arrow : on the tyre
wall shows the direction of rotation.
Make sure that arrow : is pointing in the
direction of travel when fitting the tyres.
Bicycle valve
:
Sclaverand valve
;
Knurled nut (ride position)
=
Valve cap
The ebike rims are designed for tubes with
Sclaverand valve :. Once you have checked
the tyre pressure or inflated the tyre,
tighten knurled nut ;.
Make sure that a valve cap is always used to
protect valve =.
Flat tyre
If possible, always replace the tube
(Y page 70) after a puncture. This ensures
the optimum trueness of your wheels.
Transporting the ebike
!
When transporting the ebike, make sure
that no objects can become caught in the
Carbon Drive belt. The Carbon Drive belt
is particularly at risk when you trans-
port the ebike with other bicycles or
with the rear wheel removed.
Please observe the following information
to avoid damaging your ebike during
transport
X
With the wheels removed: slide the yellow
transport locks into the brake callipers.
X
Pull on the brake lever and fasten it to
the grip using a strong elastic band or a
cable tie.
X
Once you have removed the wheels, place
or lay them down carefully to prevent the
brake discs from becoming bent or dirty.
X
After storage or transport upside down:
check the operation of the brake system
and if in doubt, have the brakes bled at a
qualified specialist workshop.
X
Remove the battery before transporting
the ebike (Y page 41).
X
Place the rubber cap over the electrical
contacts in the battery holder.
X
Before transporting the ebike on a vehi-
cle's rear rack or roof carrier, remove
any accessories that are not permanently
attached to the ebike, e.g. control con-
sole, smartphone and mesh pockets.
i
It is not permitted to carry the smart
ebike battery on board a passenger aero-
plane.
The weight of the ebike and the frame
design place specific demands on a vehi-
cle's rear rack or roof carrier. Unsuitable
bicycle racks may break during a journey
or may not hold the ebike securely.
Only use suitable bicycle racks for trans-
porting the ebike. Observe the information
on roof load and noseweight in the vehicle
Owner's Manual and the information in the
bicycle rack's assembly/operating
instructions.
Transporting the ebike
45
>> Operation.
Z

Table of Contents

Other manuals for SMART ebike