SMART ebike - Page 30

erator level, you must first reduce the
generator level with button ;.
X
To reduce the drive level: press button
=.
Generator mode: selecting the genera-
tor level
G
WARNING
If the generator mode is activated or you
apply the front wheel brake, the electric
motor will brake the rear wheel. The rear
wheel could lock and lose grip on smooth or
slippery road surfaces. There is a risk of
an accident.
R
Always deactivate the generator on
smooth or slippery road surfaces.
R
If possible, only brake with the rear
wheel brake on smooth or slippery road
surfaces.
Generator mode: generator level 3 (example)
:
Generator level bar indicator
;
Button f
=
Button g
The generator level determines how much
braking power the electric motor should
provide to brake the ebike in generator
mode. The generator level also controls how
much braking power is used to recharge the
battery. You can select between four gen-
erator levels (Y page 36).
i Please bear the following in mind:
R
Once you have selected a generator
level, the ebike will use regenerative
braking until the generator mode has
been deactivated again.
R
If you apply the front wheel brake, the
electric motor will automatically
apply the rear wheel brake even if the
generator mode is deactivated. The
level of braking power applied to the
rear wheel depends on the riding speed
and cannot be regulated. Exception:
the rear wheel brake will not be
applied automatically if the battery is
fully charged.
X
To switch on the generator mode: press
button = on the control console.
G will appear in the display. Bar indi-
cator : shows which generator level you
have selected. If you have already set a
drive level, you must first reduce the
drive level with button =.
X
To increase the generator level: press
button =.
X
To reduce the generator level: press
button ;.
X
To switch off the generator mode: press
button ; repeatedly until G disappears
from the display.
28
Selecting the drive/generator level
>> Controls.