Checking the brake pad wear
Brake pads fitted
Brake pads removed
:
Brake pad
;
Yellow transport lock
X
Allow the components to cool down, if
necessary.
X
When fitted: insert thick end of transport
lock ; between the tabs of the backing
plates of brake pads :.
If transport lock ; no longer fits
between the tabs, the brake pads are worn
and must be replaced.
X
When removed: remove brake pads :
(Y page 63).
X
Measure brake pad : at its thinnest
point with a calliper gauge.
If the brake pad thickness is less than
2.5 mm (0.1 in), brake pads : are worn
and must be replaced.
or
X
Insert brake pad : into the side slot on
transport lock ;.
If brake pad : fits into the slot, the
brake pads are worn and must be
replaced.
X
Install brake pads :(Y page 64)
Checking the brake disc wear
Regularly measure the thickness of brake
discs : with a calliper gauge. The mini-
mum thickness ; of 1.8 mm (0.07 in) is
printed on the brake discs. The entire
friction ring should not be below this
thickness. If this is not the case, the brake
disc must be replaced immediately at a
qualified specialist workshop.
Checking the headset
:
Frame
;
Gap
=
Fork
48
Maintenance and care
>> Operation.
To Next Page
Loading...