SMART SBID-6065 - Page 17

CHAPTER 1
WELCOME
9 smarttech.com/kb/171166
No. Name Procedure
1 Standby
l
Press to exit Standby mode.
l
Press twice to enter Standby mode.
l
Press and hold to reset the display.
2 Select
l
If the on-screen display menu isn’t open, press to switch
inputs.
l
If the on-screen display menu is open, press to open the
currently selected menu.
2
3
Mute
l
Press to mute or unmute the volume.
l
Press and hold to freeze and unfreeze the screen (see
page24).
4 Decrease
l
If the on-screen display menu isn’t open, press to decrease
the volume.
l
If the on-screen display menu is open, press to decrease the
value of the currently selected option.
2
5 Increase
l
If the on-screen display menu isn’t open, press to increase the
volume.
l
If the on-screen display menu is open, press to increase the
value of the currently selected option.
2
6 Move Up
2
Press to move to the previous option in the current menu.
7 Move Down
2
Press to move to the next option in the current menu.
8 Menu
2
l
If the on-screen display menu isn’t open, press to open the on-
screen display menu.
l
If the on-screen display menu is open, press to return to the
previous menu.
l
Press and hold to close the on-screen display menu.
IMPORTANT
l If there is a film over the front control panel, remove it before using the front control panel.
l If the buttons don’t respond when you press them, the front control panel might have been
disabled. To re-enable the front control panel, press the Standby button until the buttons
light.
In normal operation, all buttons are white.
2
SBID-6000 models only