SMART SBID-6065 - Adjusting Audio; Freezing the Screen

CHAPTER 2
USING THE DISPLAY
18 smarttech.com/kb/171166
The Standby button also functions as an indicator light:
Indicator light Status Procedure
Solid white Normal operation [N/A]
Off Not receiving power
l
Confirm the display’s power cable is
connected to the power outlet.
l
Flick the switch beside the AC power inlet
to the ON(I) position.
Solid amber DPMS (power
management) mode
l
Press the Standby button to exit
DPMSmode.
l
Connect an input source.
Slowly flashing
amber
Standby mode
l
Press the Standby button to exit
Standby mode.
l
If presence detection is enabled, move in
range of the presence detection sensor.
l
If Wake to Touch is enabled, touch the
screen.
Flashing amber No USB connection from
the connected computer
l
Verify the connections to the computer.
l
Switch to the computer’s input.
See Viewing a connected computer’s
input on page26.
Slowly flashing
white
SMARTBoard service not
running on the connected
computer
Ensure that SMART Product Drivers is
installed and that the SMARTBoard
service is running.
Adjusting audio
If you’re presenting content with sound, you can use the buttons on the front control panel to
increase, decrease, mute and unmute the volume (see Front control panel on page8).
Freezing the screen
You can temporarily freeze the screen by pressing and holding the Mute button on the front
control panel (see Front control panel on page8). This is particularly useful when you want to
pause a video, an animation or other moving content.
NOTE
Freezing the screen does not pause any applications running on the connected computer. It
simply freezes the display of those applications.
To unfreeze the screen, press and hold the Mute button again.