Chapter 2
Using basic features
smarttech.com/kb/171554 19
SMARTBoard MX (V3, V2 and V2-C) series
The image and table below list the remote control’s functions.
No. Name Procedure
1
Power
l
Press to enter or exit Standby mode (see Waking up the display and
putting it back to sleep on page16).
NOTE
Touch is not available right after waking up the display or turning it
on. Wait a few seconds and then the display will respond to touch.
l
Press and hold for four seconds to turn off the display.
2 Home
Open the iQ Home screen (see Using the Home button on page17).
3 Up and down
buttons
Select a menu option in the settings.
4 OK Select menu option in the settings.
5 Left and right
buttons
Change the value of the selected setting.
To Next Page
Loading...
Need help?
General
