Radlabor GmbH | Heinrich-von-Stephan-Str. 5c | 79100 Freiburg | Germany
www.smartfit.bike | www.radlabor.de
Then fix the sensor using the two adjustment screws. Tighten the screws alternating. It means first
a little the left, then a little the right, until the screws fixing the sensor in position.
Make sure, that the cone of the adjustment tool stays in the center of the bottom bracket screw:
After the adjustment screws fixing the sensor, tight the sensor – crank-screw:
Then you can take off the adjustment tool.
To Next Page
Loading...