Important warnings
Please read the following warnings, before beginning to use your PowerForce System. Otherwise,
your PowerForce could be damaged, or not function properly.
✓ Do not over tight the pedals in the PowerForce System. Give some grease to the
connective sites to improve the reassembling of the pedals.
✓ If your open a sensor, the transmitter unit or the connection box, the warranty is no
longer valid.
✓ Never clean the sensor or the transmitter unit with water or use it in wet conditions.
✓ Do not cramp the position switch – it is sensitive for pressure.
✓ Check before each ride, that the sensors and the pedals are fixed properly.
✓ When unplugging any connection, always pull straight down rather than sideways,
or you could damage connector pins. Never pull on the cable itself, but rather the
plug.
✓ Carefully read through the full installation instructions before beginning, as
mounting the PowerForce System incorrectly can cause a fall or damage the
system.
✓ Do not load the sensor with loads higher than 300kg.
To Next Page
Loading...