ALC700 Series Light Tower Set Controller
ALC700 Series Light Tower Set Controller 2018-03-02 Version 1.4 Page 38 of 51
Action when over speed shutdown alarm.
Preheat (during preheat
timer)
Action in period of preheat delay to cranking.
Preheat (until end of crank)
Action in period of preheat delay to the end of cranking
delay.
Preheat (until end of warm
timer)
Action in period of preheat delay to the end of warming
up delay.
Preheat (until end of safety
on)
Action in period of preheat delay to the end of safety
on delay.
Action when over speed warns.
Action when over speed shutdown alarm.
Action during “cranking---start idle” period and “stop
idle --- fail to stop” period.
Actions in period of cranking to safety on.
Action in warming up delay.
Output in start period. If there is no generator
frequency during hi-speed running, output for 2
seconds.
Action between the period from “stop idle” to “failed to
stop”.
Actions in period of pre-heat to safety on.
Action when generator crank disconnect in auto mode.
Press button, control output.
Action when there are 10s left from start time in auto
start mode.
Control genset via utility software or remote
communication.
Control the power supply of GSM modem.
NOTE: The contents of output port 1~4 can be set only via PC software.